Remove Sxxx but keem the 'M03 if you have a relay to turn on the router.Also, keep the x and y locations on that line. This line will also contain the spindle speed. If the program you have contains 'G54' near the third line, this code needs to be removed. ![]() If it contains G90, keep that code.ĬNC machines use fixture offsets to tell the control where the origin of the part is. Near the top of the program is a line referred to as the 'Safety Block' It will include G40,G80,G49 etc. ![]() Mastercam will post a lot of code at the beginning of the program that is not needed by shopbot. Depending on what post processor was used a little editing will have to be done.
0 Comments
Leave a Reply. |